ANSR: PREP Wet face and gently massage the refreshing cleanser into a lather. Leave on your skin for an additional 20 seconds to allow the ingredients to work. If drying of the skin occurs, start by leaving ANSR: Prep on the skin for 5 seconds, and gradually build up to the full 20 second application. Rinse thoroughly and pat skin dry. Avoid eye area when cleansing with PREP.
ANSR: BEAM Once you've thoroughly cleansed your skin, you're ready to apply both BLUE and RED photolight to the affected areas. Press the BEAM "ON" button for BLUE LIGHT and place directly on the skin. The BEAM will vibrate slightly to let you know it's working. Using a slow, sweeping motion, gently run the unit along the surface of your skin for 5 minutes. BEAM will then automatically switch to deep penetrating RED LIGHT waves for 5 minutes, followed by automatic shut-off. (You can manually cycle from BLUE to RED by switching the button off and then on again.)
ANSR: DAY After treatment with light, apply a layer of DAY lotion to acne prone areas. Gently massage until absorbed into the skin. If drying of the skin occurs, begin with a spot application, and gradually build up to application over the entire afflicted area. You may apply makeup directly following application of ANSR: Day.
ANSR: NIGHT Cleanse skin and treat with light, as in the morning. Apply a layer of NIGHT gel to acne prone areas. Gently massage until absorbed into skin. If drying of the skin occurs, begin with a spot application, and gradually build up to application over the entire afflicted area.
